Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Get your free estimateStyles & brands we work with
See the difference
Before
After
Before
After
Before
AfterCable Repair in San Antonio, TX
Garage door cable repair in San Antonio typically costs between $150 and $350, depending on whether one or both cables need replacing and how much the door has shifted out of alignment. Most cable repairs take under an hour once a technician arrives, and Fernbrook Garage Doors San Antonio handles them the same day in most San Antonio neighborhoods. If your door is hanging unevenly or making a scraping sound, call our home office team at (806) 602-8374 and a live person will answer, day or night.
Cables do the heavy lifting on your garage door. They work with the springs to raise and lower the door smoothly, and when one fails, the entire system goes out of balance. Our technicians are trained on eight major brands including Amarr, Wayne Dalton, and Raynor doors, so we can match the right cable to your existing hardware rather than forcing a generic part. This matters more than most people realize: a mismatched cable wears unevenly and puts strain on the opener, the hinges, and the spring. Learn more about the full scope of our work on our Garage Door Repair in San Antonio page.
Key takeaways:
- Cable repair in San Antonio usually runs $150 – $350 per job.
- Most cable failures happen suddenly, but the warning signs are predictable.
- We write the price down before any work begins, every visit.
- A live person answers our phone 24/7, including weekends.
- Every cable repair is backed by our 365-Day Done Right Promise.
When You Need Cable Repair
Cables rarely fail silently. There are almost always signs in the days or weeks before one gives out, and catching them early usually means a smaller bill. Here is what we see most often in San Antonio, from Alamo Heights to Stone Oak to the West Side:
- The door hangs crooked or jerks when opening. If one side rises faster than the other, a cable is likely fraying or has slipped off its drum. This is the most common sign we see in San Antonio garages, especially on older doors with original cables.
- You can see broken strands or rust on the cable. San Antonio’s humidity, especially in neighborhoods near Salado Creek or the Medina River corridor, accelerates rust on galvanized cable. Any visible fraying means the cable has lost strength and should be replaced before it snaps.
- The door makes a loud bang and then won’t move. A snapped cable releases tension suddenly. The door often drops a few inches on one side. Do not keep pressing the opener button. Call us at (806) 602-8374 and we will talk you through securing the door until a technician arrives.
- The cable has come off the drum at the top of the track. You may see a loose cable dangling or wrapped around the shaft. This can happen when the door hits something, when a roller wears out, or when the door was manually opened while the spring was broken.
- The door sounds heavy or the opener strains. When one cable is compromised, the other cable and the spring take on extra load. The opener works harder, which shortens its life and can burn out the motor if ignored for months.
- Your spring was replaced recently but the cable wasn’t checked. In San Antonio, temperature swings between winter cold snaps and summer heat put real stress on metal parts. After any spring repair, both cables should be inspected. Some companies skip that step; we don’t.
A snapped cable is not something to fix yourself. The cables are under tension from the springs, and the spring itself holds enough stored energy to cause serious injury. Our technicians carry the right tools and the right replacement parts for Amarr, Wayne Dalton, and Raynor systems, and they know how to safely release tension before touching any cable. For safe, professional help, call our Garage Door Repair services team.
Our Cable Repair Process
Here is exactly what happens on a cable repair visit from Fernbrook Garage Doors San Antonio. We believe knowing the process before the technician arrives removes most of the stress from the call.
- You call and a person answers. No phone tree, no “press 2 for service.” You describe what the door is doing, we give you an honest sense of whether it’s urgent, and we schedule a time that works for your family. If the door is stuck open or won’t close, we treat it as a priority.
- The technician arrives in uniform and introduces himself. He’ll put on shoe covers before walking through your home, lay down a drop cloth in the garage entry area, and ask before moving anything, including bikes, strollers, or a dog crate near the door tracks.
- We inspect the full system and write down the price. We look at both cables, the spring, the rollers, the tracks, and the opener. Then we present a written price before any work begins. No exceptions. You approve the number, we do the job.
- We replace the cable or cables and rebalance the door. This involves safely releasing spring tension, removing the broken or frayed cable, installing a new cable matched to your door’s make and weight, and winding everything back to the correct tension. We use pet-safe lubricants on moving parts where a lubricant is needed.
- We test the door through a full open-and-close cycle. We listen for scraping, watch the cable seating on the drums, and check that the door sits level. If the opener is straining, we tell you and show you what we’re seeing.
- We clean up and show you a photo of the clean area. Before we leave, we take a photo of the workspace and show you. If anything came loose during the job, we ask before moving it back. Your garage looks like we were never there, except the door works again.
Cable Repair Pricing in San Antonio
Here are the honest numbers. If you’re wondering How Much Does Garage Door Repair Cost? (2026 Price Guide) - San Antonio, TX, cable repair generally falls into these ranges depending on what we find when we open the door:
| Service | Typical Price Range in San Antonio |
|---|---|
| Single cable replacement (standard 7 ft door) | $150 – $220 |
| Both cables replaced (standard 7 ft door) | $220 – $300 |
| Cable replacement on 8 ft or heavier custom door | $250 – $350 |
| Cable plus roller replacement (per roller) | $20 – $40 added per roller |
What drives the price up or down? A few things. Heavier doors, like solid wood carriage doors found in older Monte Vista or King William homes, need heavier cables and take longer to balance. If the door has shifted in its tracks from running unevenly for weeks, we may need to adjust or replace track brackets too. And if the spring is near the end of its life, we’ll tell you before we start, not after we’re done. Families who replace both cables at once usually avoid a second service visit within a year or two, because cables wear at similar rates.
Every cable repair quote is written down and handed to you before any work begins. That is not a limited-time offer or a special. That is how we have operated since Jesse Calder started running Fernbrook locations. You’ll know the exact price, and you’ll approve it before we touch a single part.
Call (806) 602-8374 for a free estimate on cable repair in San Antonio, or search Garage Door Repair Near Me in San Antonio, TX to find us. The estimate is free, the advice is honest, and no one will pressure you into a repair you don’t need.
FAQs – Cable Repair
How much does it cost to repair a garage door cable in San Antonio?
Most single-cable replacements in San Antonio run between $150 and $220, while a full set of both cables typically costs $220 to $300 depending on your door’s weight and size. The best way to get an exact number is to call (806) 602-8374 for a free estimate, and we’ll give you a written price before any work begins.
Can a garage door work with one broken cable?
A garage door cannot operate safely with one broken cable; the remaining cable and the spring absorb the full load, which pulls the door out of alignment and can damage the opener motor, the track, and even the door panels themselves. In some cases, Panel Replacement may be needed if the damage has already occurred. If one cable has snapped, stop using the door and call us at (806) 602-8374 so we can secure the door and replace the cable before other parts fail.
How long does cable repair take?
Most cable replacements take 45 minutes to an hour once our technician is on site, assuming the track and rollers are in good condition. If the door has been running unevenly long enough to wear down other hardware, the visit may take 90 minutes or more. We’ll give you a realistic time estimate when you call (806) 602-8374.
Is it safer to repair or replace my garage door if the cables keep breaking?
If your cables have broken twice within a few years, the problem is usually not the cables, it’s something else in the system: a wrong-sized spring, worn rollers, or a door that’s too heavy for the original hardware. In some cases, especially on 15-year-old doors with rusted tracks and sagging panels, replacement costs less over two years than repeated repairs. We’ll give you a straight answer after inspecting the door, with numbers for both options.
If you have questions about a garage door cable that looks worn, a door that opened fine yesterday and now won’t budge, or a cable you found dangling when you pulled in from work, call Fernbrook Garage Doors San Antonio at (806) 602-8374. A live person answers at 3 in the afternoon and at 3 in the morning. We’ll help you figure out what’s happening, tell you what it will cost, and if you want us to come out, we’ll be there with shoe covers, a drop cloth, and a written price before we start.
Written by Jesse Calder, Owner at Fernbrook Garage Doors San Antonio, serving San Antonio.